
PRINTED IN UNITED STATES OF AMERICA p/n 76116 Rev. E ECN-12888
BREWING TEA 8 A. PREPARATION Examine the tea brew chamber to verify that the short the wire rack is in place. Place on
CLEANING INSTRUCTIONS PROCEDURE: Clean Tea Brewer PRECAUTIONS: Disconnect brewer from electric power. Allow brewe
TROUBLESHOOTING SUGGESTIONS SUGGESTED REMEDY Check power supply cord Check / reset circuit breaker Set for desired temperature Allow to cool hi-lim
SERVICING INSTRUCTIONS CAUTION Electric Shock Hazard Opening access panels on this brew may expose uninsulated electrical components. Disconnect brew
SERVICING INSTRUCTIONS (continued) 12 TEMPERATURE ADJUSTMENT Unplug power cord or turn circuit breaker OFF. Remove top panel. Pull vent tube out o
SERVICING INSTRUCTIONS (continued) IMPORTANT: Water pressure must be between 20 p.s.i and 90 p.s.i. flowing pressure. If water pressure excee
SERVICING INSTRUCTIONS (continued) REPLACE HEATING ELEMENT Remove tank cover assembly (see page 13). Remove two hex nuts holding element to cover.
SERVICING INSTRUCTIONS (continued) 15 CAUTION - CHEMICAL BURN HAZARD Deliming chemicals are caustic. Wear appropriate protective gloves and goggles
8742 - 8748 EXPLODED VIEW & PARTS LIST 16 606 Owners Manual for 8742-8748 Tea Brewer 76116
8742 - 8748 EXPLODED VIEW & PARTS LIST (continued) 17 606 Owners Manual for 8742-8748 Tea Brewer 76116
NOTE: For your protection, please note that equipment in this shipment was carefully inspected and packaged by skilled personnel before leaving the f
8742 - 8748 SERVICE KITS 18 SOLENOID REPAIR KITS (SKINNER SOLENOID ONLY) 8541-120CS Coil Assembly (
8742 - 8748 WIRING DIAGRAM 19 606 Owners Manual for 8742-8748 Tea Brewer 76116
PRINTED IN UNITED STATES OF AMERICA Bloomfield Industries, Inc.Division of Carrier Commercial RefrigerationIn US and CanadaTelephone: 775-698-5700Fax:
MODEL DIMENSIONS VOLTS WATTS AMPS 1ø POWER SUPPLY CORD 8742 3 Gallon Iced Tea Brewer 32-1/4" high 10-15/16" wide 15-11/16" deep 120
FEATURES AND OPERATING CONTROLS 2 606 Owners Manual for 8742-8748 Tea Brewer 76116
PRECAUTIONS AND GENERAL INFORMATION 3 WARNING: Electric Shock Hazard All servicing requiring access to non-insulated components must be performed by
INSTALLATION 4 READ THIS CAREFULLY BEFORE STARTING THE INSTALLATION Unpack the unit. Inspect all components for completeness and condition. Ensure t
INSTALLATION (continued) 5 NOTE: This equipment must be installed to comply with applicable federal, state and local plumbing codes and
OPERATION Fig. 3 Brewer Operation Diagram A. START-UP For initial start-up, or if the brewer has not been used for an extended
OPERATION (continued) WATER HEATER Water temperature is sensed by a thermobulb inserted into the water tank. This temperature signal is fed t
Comments to this Manuals