Bloomfield GOURMET 1000 8792 User Manual download pdf (Page 7)

INSTALLATION INSTRUCTIONS (continued)

NOTE: This equipment must be

installed to comply with

applicable federal, state and

local plumbing codes and

ordinances.

WARNING:

SHOCK HAZARD

Brewer must be properly

grounded to prevent possible

shock hazard. DO NOT

assume a plumbing line will

provide such a ground.

Electrical shock will cause death

or serious injury.

IMPORTANT: Do not connect

brewer to electrical power until

both tanks are filled with water.

Pour water into each pour-over

opening until water flows from

the respective brew head.

IMPORTANT:

Supply power must match

nameplate for voltage and

phase. Connecting to the

wrong voltage will damage the

brewer or result in decreased

performance. Such damage is

not covered by warranty.

NSF requires that the brewer be able to be moved for cleaning

underneath. A flex line or loops of copper tubing will satisfy this

requirement. See Figure 2 below.

In some areas, local codes require a backflow preventer (check

valve) to be installed on the inlet water line. If a backflow

preventer is used, you must install a water hammer arrester in

the incoming line, between the backflow preventer and the

brewer inlet, as far away from the brewer as space will allow.

This will relieve the excessive back pressures that can cause

faucet leaks and solenoid malfunctions.

ELECTRICIAN’S INSTALLATION INSTRUCTIONS

REFER TO ELECTRICAL SPECIFICATIONS - Page 1

Check the nameplate to determine correct electrical service

required for the Brewer to be installed.

IMPORTANT: Before connecting to electricity, make sure

automatic brewers are connected to the water supply.

Gourmet 1000™ dual brewers must be wired by an electrician.

Model 8792 requires a 120/240V 20A circuit (50/60 Hz, L1, L2,

Neut. plus Ground).

Remove front panel to gain access to terminal block. Green

terminal must be connected to a suitable building ground. Circuit

must be capable of 4000 Watts. See figure 3 at right.

IMPORTANT: Wiring must be installed in approved solid or

flexible conduit, and must be secured to the brewer with a strain

relief (to be provided by the installer).

Fig. 3 115/230 Volt Terminal Block

Fig. 2 Water Supply Installation

625 75873 Owners Manual Gourmet 1000 Dual Airpot Brewers

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

Comments to this Manuals

No comments

Bloomfield GOURMET 1000 8792 User Manual Page 7

Comments to this Manuals

Related products and manuals for Coffee machines Bloomfield GOURMET 1000 8792